PDA

View Full Version : XJ caster angle?



NT-Boy
07-12-09, 01:04 PM
After fitting a front lift to the XJ last week and driving it around ive noticed the car moving from left to right!!!!

I'll be checking the TOE-ROD and STEERING again.

My Question is with the CASTER ANGLE?


http://i982.photobucket.com/albums/ae308/NT-Boy/controlarmdiagram1.gif

A.... Adjust the upper c/arms forward?

B.... Adjust the upper c/arms back?


And how do i check if did diff is straight? is it done by checking the length of the lower control arms? I think the lift side is a bit forward !!!!

Steve F
07-12-09, 02:51 PM
Adjust the uppers back or the lowers forward, the lowers have provision for factory adjustment so I normally go with those as these are the ones they adjusted at the factory for caster and pinion angle. It will also lengthen the wheelbase rather than shorten it, of course it does depend how long you have the control arms, ideally you want to aim to have the wheel in the centre of the arch. To check the diff is straight measure the wheelbase on either side, so somewhere consistent on each rear wheel to a consistent spot on the front wheel. The front mounting points may not be 100% :)

Cheers
Steve

NT-Boy
07-12-09, 06:39 PM
Thanks Steve F.