Tool Box Day - 6th Apri l2013

[Wolfe]

It's only one day, you might get the front in or maybe the rear but I doubt both. I've done it before if you need some assistance, I could work on the left while you do the right, the rights a bit harder as you have to get it around the peddles but other than that they are pretty much the same side to side

Cheers
Steve

you guys are mad attempting to do such a complicated job like that, i can just see the disaster now, you'll get the side mixed up then ...................

[Wooders]

And I thought Hunno was optimistic that we could convert wolfies old black XJ into a camper.

[Wolfe]

And I thought Hunno was optimistic that we could convert wolfies old black XJ into a camper.

Great idea Hunno and far more achievable, dont know what those knuckleheads were thinking

[Wooders]

If we get bored we can also start on the Car Trailer build

[SteveC]

Thanks about the advice for my mats. I feel so relieved that I'll have professionals around , should we get there early just in case? what time will the shop be open?

[chipper]

So can you put me down to get ball joints replaced on toolbox day?
or is it too long/big job for this type of day?
chipper

[reyzor]

Thanks about the advice for my mats. I feel so relieved that I'll have professionals around , should we get there early just in case? what time will the shop be open?

wouldnt this task affect warranty?

[Miraz]

Not if it is signed off by a suitably qualified engineer

[SteveC]

Don't tell any one but I fitted the mats today under the secrecy of darkness and sourced them from a strange fellow type bootlegger that runs out of the Hornsby area, but keep it quiet. shhhhh!

ps he was very supportive with his instructions,

[redrubi]

I'm telling!
Steve it wasn't this man was itDSCN0252.jpg?