Anyone know someone in Sydney that can do the welding for the C gussets and to check the housing is nice and straight?
Anyone know someone in Sydney that can do the welding for the C gussets and to check the housing is nice and straight?
Shents Automotive in the central coast i believe can do it but dont quote me on that.
Any closer to sydney
Overkill Engineering Hornsby. Facebook.
shents would be my first pick..... its only 40 mins up the freeway.......
You could ask John at J-mac diff & gears in Arndell Park. He has built a lot of the comp rigs for tuff truck etc.
JC Member# 094
Any from the above done this job before?
Any of those should be able to do it. Done a few myself and they are fairly straight forward.
Sent from my GT-N7105T using Tapatalk
Yes I can.
Its extremely unlikely that the centre (cast section) is bent, its usually the tubes, and the sleeves are usually a snug fit inside. So you'd know pretty quick if theres a bend
But yes checking is usually part of the process. With external trusses I usually check afterwards too so to ensure the welding hasn't wrapped the housing. But this isn't an issue with sleeves.
Sent from my GT-N7105T using Tapatalk
Bookmarks